VHW-HWPO Veracity Coax to Ethernet Converter with PoE

HIGHWIRE POE turns existing video infrastructure into a fast network connection, and converts legacy 12V or 24V power into a universal Power over Ethernet (PoE) supply for IP cameras and mega-pixel cameras. This saves the time and cost of replacing old analog cabling, with no need to install extra power for the new camera. Instant operation with no configuration required makes installation of HIGHWIRE POE simple and fast.

Specifications:

HIGHWIRE INTERFACE:

• Connector type: BNC 75ohm
• Cable impedance: 75ohm (RG59 or similar)
• Cable length max: Up to 800ft for full data rate (or up to 1100ft at a reduced rate)
• Data throughput max: 200Mbps (total up + down). Auto-adaptation to cable conditions.

ETHERNET INTERFACE:

• Connector type: RJ45
• Cable type: Straight through or cross-over, auto detected
• Rates supported: 100BaseT / 10BaseT, full/half duplex with auto negotiation

LED INDICATORS:

• Green – Constant: Power OK, Full HIGHWIRE data link
• Green – Slow: Power OK, Auto-adapted HIGHWIRE data link
• Green – Blink: Power OK, no HIGHWIRE link
• Green – Off: No power
• Amber – Constant: Ethernet link On
• Amber – Blink: Network traffic

POWER SUPPLY:

• Connector type: Screw terminals with detachable plug
• Power supply type: IEC Class II isolated only
• Operating voltage: Nominal 12V DC (9-24V working range) or 24V AC (type and polarity auto detected)
• Supply current: 200mA (12V), 100mA (24V)

ENVIRONMENTAL:

• Operating temp.: 14ºF to 122ºF
• Relative humidity: 85% non-condensing
• Grounding: Chassis should be grounded and is connected to the BNC shield.
• Dimensions: L 4.01” (3.27” excl. conns.) x W 2.13” x H 0.91”
• Weight: 4 oz. (110g)
• Compliance: FCC, CE, RoHS

VHW-HWPO Specifications PDF